Learn · Grade 7 Science

Investigate a paper bridge

Separate observation, comparison, experiment, and engineering.

Original curriculum. These lessons and questions have not been independently reviewed.

01 · Learn the idea

Begin with an observation and a safety plan

A sheet bridging two supports bends when a small load is added. Describe the bending without explaining it yet. Compare a flat sheet with a folded sheet and ask: “How does a lengthwise fold affect the mass supported across the same gap?” An observation describes; a comparison identifies differences; a controlled experiment changes a chosen factor.

Use only teacher-approved paper, stable low supports, and light nonsharp mass pieces over a tray on a desk. Before testing, the teacher reviews applicable TEA-approved safety procedures and selects eye protection and other equipment for the materials. Demonstrate safe placement, keep hands and faces out of the collapse area, report dropped pieces or damage, and clean up as directed. Stop if the setup is unstable.

02 · Build understanding

Control what could change the result

Use the same paper type and size, 0.15-m gap, load position, and loading increments for both designs. Change only the fold pattern. Measure dimensions with a metric ruler; use a balance to record supported mass in kilograms. Add pieces gently until the bridge no longer supports them; record the greatest mass supported before failure, not the collapsing load. Use a fresh bridge for each of three trials.

Before testing, make a table with design, trial, supported mass, and qualitative notes. For practice only, invented results are flat: 0.020, 0.025, 0.015 kg; folded: 0.050, 0.060, 0.055 kg. Means are 0.020 and 0.055 kg; ranges are 0.010 kg for each. Draw a bar graph of mean supported mass with units. The folded mean is 0.035 kg greater.

03 · Build understanding

Evaluate and improve

These results support a claim about these materials and this setup, not every bridge. Unequal spans, reused damaged paper, or off-center loads weaken the comparison. Repeated trials reveal variability but do not fix a consistently wrong ruler reading.

For an engineering challenge, require a bridge to support 0.040 kg across the same gap using one sheet. Compare the trial evidence against that criterion, sketch one revision, predict its effect, and retest safely. Engineering asks whether a solution meets criteria and constraints; it may require several designs.

Apply and explain

Your turn

With your teacher, carry out the description, comparison, and three-trial bridge experiment. Record measurements, means, qualitative observations, and a graph. Evaluate whether your design meets the 0.040-kg criterion and propose a revision. If physical testing is unavailable, analyze the supplied invented data and write the experimental plan, clearly labeling that you did not conduct it.

Use paper or explain your thinking aloud before opening the solution.

Check your reasoning

The supplied data give means 0.020 and 0.055 kg; only the folded design meets the criterion in every supplied trial. Actual conclusions must match the student’s own measurements. Valid plans hold span, paper, load location, and increments constant and state safety steps, error sources, and a testable revision.

  • Distinguish performed measurements from supplied examples.
  • Apply the teacher’s safety procedures and suitable tools.
  • Record three trials with SI units and means.
  • Evaluate controls, variability, and design constraints.

Ready to practice?

Try the questions, get feedback, and review your reasoning.

Investigate a paper bridge practice →