01 · Learn the idea
Observe and ask
Use two sessions of about 25 minutes with prepared materials. First inspect the paper, agree on the setup, and complete the flat and folded trials. Then compare the results, redesign, retest, and explain the outcome. Allow extra time for setup if your teacher needs it.
A sheet of paper laid between two low supports sags under a small load. Describe what you see before explaining it: the middle bends downward. Inspect two equal sheets and record their length, width, texture, and flexibility. This descriptive investigation documents properties without deliberately changing a test condition.
A testable question is: does folding this paper into an accordion shape change how much its center sags under the same load? The engineering problem is to make a paper bridge spanning 15 cm that sags less than a flat sheet while supporting a teacher-selected light load.
02 · Build understanding
Plan and conduct safely
With teacher supervision, use two low supports on a tray, equal sheets, a metric ruler, notebook, and a light reusable load. Follow the teacher’s equipment directions, wear the required eye protection during load tests, keep faces away from the bridge, and keep the tray clear so a falling load cannot strike a foot. Stop if the supports move.
Compare a flat sheet with a sheet folded back and forth into equal-width pleats. Change the fold design only. Keep the paper size, gap, load, and load position the same. Measure the center height before and after adding the load; subtract to find sag in centimeters. Repeat each design three times with fresh matching sheets. Record every result, including a failed bridge.
03 · Build understanding
Build and improve
Sketch the bridge and label its gap and folds. This prototype is a test version, not a real bridge for people. Use your results to choose one change, such as a different pleat width. Rebuild and retest under the same conditions. A design decision needs evidence, not just a preference.
Apply and explain
Your turn
Conduct the descriptive inspection and supervised bridge test. Record the question, safety steps, changed and controlled conditions, and three sag measurements for each design. Make one evidence-based redesign and retest it.
Use paper or explain your thinking aloud before opening the solution.
Check your reasoning
Results will vary. A complete response includes observed paper properties, a question about fold design and sag, the stated safety practices, matching gap/paper/load conditions, measured sag with units for all trials, and a labeled redesign. Claim an improvement only if comparable results support it; an unsuccessful redesign is still useful evidence.
- Record actual observations rather than invented successful results.
- Keep all conditions except the tested design the same and follow safety directions.
- Use repeated measurements to explain the redesign.
Ready to practice?
Try the questions, get feedback, and review your reasoning.
From observations to a fair test: practice →