Learn · Grade 5 Science

Trace a working electrical system

Build a closed path and identify changes in energy.

Lesson 2 of 3About 25 minutesTEKS 5.8(A)TEKS 5.8(B)TEKS 5.5(D)

Original curriculum. These lessons and questions have not been independently reviewed.

01 · Learn the idea

Build the whole path

Use only teacher-approved low-voltage classroom components. Connect a battery, wires, switch, and matching small lamp so a conducting path goes from one battery terminal through the lamp and back to the other terminal. Close the switch and observe. Open it and observe again. Do not connect battery terminals directly without a suitable device in the path.

Draw a loop and label each part. The battery supplies energy, wires provide a conducting path, the switch opens or closes the path, and the lamp changes electrical energy into light and thermal energy. A gap anywhere in this simple loop prevents steady current.

02 · Build understanding

Energy changes form

In a battery-powered flashlight, stored chemical energy supplies electrical energy in the circuit; the lamp produces light and some thermal energy. Energy is transferred and transformed, not made from nothing.

Under supervision, substitute a suitable motor or buzzer for the lamp, one at a time. The motor produces motion; the buzzer produces sound. A teacher demonstration or observation of an enclosed low-voltage heating device can show thermal output without touching a hot part. All need the correct complete circuit and a suitable energy source.

Apply and explain

Your turn

Build and sketch the supervised lamp circuit, show the switch open and closed, and record results. Trace energy from battery to light. Compare one motor or buzzer circuit and explain how the parts depend on one another.

Use paper or explain your thinking aloud before opening the solution.

Check your reasoning

With working matched components, the closed circuit lights the lamp and the open path does not. Energy changes from chemical to electrical to light and thermal energy. A motor or buzzer gives motion or sound instead. Removing a wire breaks the path; a connected device still needs an energy source.

  • Draw a complete path through a device and both battery terminals.
  • Connect observations to open and closed paths.
  • Name energy transformations and the roles of system parts.

Ready to practice?

Try the questions, get feedback, and review your reasoning.

Trace a working electrical system: practice →