Learn · Grade 4 Mathematics

Measuring and drawing angles

Determine approximate angle measures with a protractor, and draw an angle of a given measure.

Lesson 6 of 7About 12 minutesTEKS 4.7(C)TEKS 4.7(D)TEKS 4.1(C)

Original curriculum. These lessons and questions have not been independently reviewed.

01 · Learn the idea

Placing the protractor

Put the centre mark of the protractor exactly on the vertex, and lay the baseline along one ray.

Both steps matter. If the centre is off the vertex, every reading is wrong, and this is the most common source of error.

02 · Build understanding

Choosing the right scale

Most protractors have two scales, one running each way, so each position shows two numbers such as 50 and 130.

Decide first whether the angle is acute or obtuse by looking at it. If it is acute, take the reading under 90; if obtuse, take the one over 90. That single judgement removes the ambiguity.

03 · Build understanding

Reading the measure

Follow the second ray out to the scale and read where it crosses, to the nearest whole degree.

If the ray is too short to reach the scale, extend it with a ruler. Lengthening a ray does not change the angle, so this is always safe.

04 · Build understanding

Drawing an angle

To draw an angle of 65 degrees, draw one ray, place the protractor with its centre on the endpoint and baseline along the ray, mark 65 on the correct scale, then join the endpoint to the mark.

Check the result: 65 is less than 90, so the angle you drew should look acute. If it looks obtuse you read the wrong scale.

Apply and explain

Your turn

Describe the steps for measuring an angle with a protractor, including how you decide which scale to read. Then describe how you would draw an angle of 130 degrees and how you would check it, and say what to do if a ray is too short to reach the scale.

Use paper or explain your thinking aloud before opening the solution.

Check your reasoning

Place the protractor centre exactly on the vertex and the baseline along one ray. Look at the angle and decide whether it is acute or obtuse; if acute read the number below 90, if obtuse read the number above 90. Follow the second ray to the scale and read to the nearest whole degree. To draw 130 degrees, draw one ray, place the protractor centre on its endpoint with the baseline along it, mark 130 on the scale above 90, and join the endpoint to the mark. Check that the angle looks obtuse, since 130 is greater than 90. If a ray is too short to reach the scale, extend it with a ruler, which is safe because lengthening a ray does not change the angle.

  • Vertex and baseline placement are both described.
  • The acute or obtuse judgement is used to pick the scale.
  • The drawing is checked against the expected appearance, and the short-ray fix is given.

Ready to practice?

Try the questions, get feedback, and review your reasoning.

Geometry and angles practice →