Learn · Chemistry

Separate how much dissolves from how fast

Separate how much dissolves from how fast

Lesson 2 of 4About 120 minutesTEKS §112.43(c)(11)(C)

Original curriculum. These lessons and questions have not been independently reviewed.

01 · Learn the idea

Plan three separate comparisons

With teacher-approved sucrose and water, design three trials changing one factor at a time: room-temperature versus teacher-supplied mildly warm water; still versus stirred water at the same temperature; and intact versus crushed sucrose of equal mass at the same stirring rate and temperature. Use the same water volume, container type, solute mass, and endpoint definition. Repeat each condition at least three times; small groups can divide the 18 runs and pool clearly labeled data.

Use small pilot-tested quantities that fully dissolve within the session, such as 2 g sucrose in 50 mL water. The teacher supplies water at a safe measured temperature, no higher than 40°C for this activity. Wear required eye protection, use clean labeled lab equipment, do not taste, and handle glassware as instructed. Record times in seconds and temperatures rather than inventing expected results.

02 · Build understanding

Read the equilibrium graph separately

Dissolution rate concerns time to dissolve a specified amount. Solubility concerns the equilibrium amount that can dissolve at a specified temperature and pressure. Stirring and crushing often speed dissolution without increasing the equilibrium limit. Many solids become more soluble as temperature rises, but some do not; many gases become less soluble in warmer water at fixed gas pressure.

Use the solid and gas solubility graphs at https://openstax.org/books/chemistry-2e/pages/11-3-solubility . Select one curve of each type, record two read-off values with units, and compare their temperature trends. Do not treat the rate experiment as a direct measurement of maximum solubility.

Apply and explain

Your turn

Submit the approved plan, actual trial table, means and ranges, and a graph for each rate comparison. Read and label two points from each selected source curve. Explain which conclusions concern rate and which concern equilibrium amount.

Use paper or explain your thinking aloud before opening the solution.

Check your reasoning

A valid result reports measured times, including incomplete trials and scatter. Faster dissolution is not proof that more can remain dissolved at equilibrium. Curve conclusions must match the specific substance and units; the direction is not universal for all solids.

  • One changed variable per comparison
  • Three repeats per condition
  • Actual measurements and spread
  • Curve units retained
  • Rate distinguished from equilibrium

Ready to practice?

Try the questions, get feedback, and review your reasoning.

Separate how much dissolves from how fast practice →