Learn · Chemistry

Test and improve an insulated container

Test and improve an insulated container

Original curriculum. These lessons and questions have not been independently reviewed.

01 · Learn the idea

Define and build

The challenge is to reduce cooling of 100 g of teacher-supplied warm water during 10 minutes using identical containers and no more than a teacher-set budget of paper/fabric insulation. Keep all water at a teacher-approved starting temperature no higher than 40°C. No flames, hot plates, sealed pressurized vessels, or chemical heat sources are used. Compare an uninsulated control and two wrapped designs.

First describe each material and predict heat-flow paths with a diagram. Plan a comparative pilot, then a controlled experiment with equal water mass, similar initial temperature, same container/lid, room location, probe placement, and timing. Run three trials per design, arranging trials to reduce time-of-day or location bias. Record temperature each minute and any deviations from the plan.

02 · Build understanding

Analyze, argue, and revise

Graph the cooling curves. Compute ΔT after 10 minutes, mean drop and range, and average cooling rate ΔT/10 min. Compare material use and teacher-supplied cost as well as thermal performance. If initial temperatures differ, address the limitation instead of simply ranking final temperatures.

Write an individual claim with data and a heat-transfer explanation. In a team review, ask peers to challenge one alternative explanation, such as thicker cups rather than better wrapping. Revise one prototype and test it again under the same conditions. Report inconclusive results when trial spread prevents a clear ranking; a prettier design is not evidence of better insulation.

Apply and explain

Your turn

Submit the approved investigation plan, actual nine-trial dataset, heat-flow models, calculations, cost comparison, and revised-design retest. Give a group presentation and an individual response explaining how peer criticism changed or strengthened the claim.

Use paper or explain your thinking aloud before opening the solution.

Check your reasoning

No predetermined design must win. A defensible choice uses controlled temperature-drop data plus stated constraints. If the revised design is not better within measurement variation, say so. Average cooling rate is a summary of a curved process, not proof the rate is constant at every minute.

  • Control and repeated trials
  • Equal starting conditions or stated limitation
  • Actual cooling curves
  • Quantitative cost/performance comparison
  • Evidence-based critique
  • Revised prototype retested

Ready to practice?

Try the questions, get feedback, and review your reasoning.

Test and improve an insulated container practice →